ISO DDIN radio provision
1. Carefully cut, and remove the bar
in the factory radio trim panel.
(Figure A)
Note: The smoother the cut, the
better the 95-7326 will look in the
dash panel.
2. Snap the ISO DDIN brackets into
the inside edge of the ISO DDIN
trim plate. (Figure B)
3. Slide the radio into the assembly
from the rear. Secure the radio to
the assembly using the screws
supplied with the radio. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash and
make all necessary connections to
the radio. Metra recommends using
the proper mating adapters from
Metra and/or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
Kit Assembly
CUT OUT BAR
CUT HERE
(Figure A)
95-7326
(Figure B)
3
(Figure C)