Kit Assembly; Important - Metra 88-00-8000 Instrucciones De Instalación

1. Remove the mounting brackets from the
factory radio assembly.
2. Align the holes in the factory mounting
brackets with the holes in the pocket, and
then secure with the (4) screws removed in
dash disassembly. (Figure A)
3. Remove the metal DIN sleeve and trim ring
from the aftermarket radio.
4. Slide the radio in the bracket/pocket
assembly using the (4) screws supplied with
the radio.
5. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Re-connect the negative battery terminal
and test the radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly
METRA. The World's best kits.
Installation instructions for part 88-00-8000

Kit Assembly

(Figure A)
metraonline.com
™

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER