Kit Assembly - Metra INST-2003 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the kit and
secure by bending the metal locking
tabs down. (Figure A)
Note: A snap-in DIN spacer has been
provided for applications where depth
is an issue. Snap the spacer in the
housing and slide DIN sleeve into
the assembly and secure by bending
metal locking tabs down. (Figure B)
3. Slide the radio back into the sleeve
until it clicks in. (Figure C))
4. Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
(Figure A)

Kit Assembly

proper mating adapter from Metra
or AXXESS. Test the radio for proper
operation.
5. Reassemble the dash in reverse
order of disassembly.
(Figure B)
(Figure C)
INST-2003
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2.
Align the holes in the ISO snap-in
brackets with the holes in the radio.
Mount the brackets to the radio with the
screws supplied with the radio. (Figure A)
3. Slide the radio assembly into the
opening of the radio housing until
the side clips engaged. (Figure B)
4. Snap the ISO trimplate over the radio.
(Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
(Figure A)
22
recommends using the proper mating
adapter from Metra or AXXESS. Test
the radio for proper operation .
6. Reassemble the dash in reverse
order of disassembly.
(Figure B)
(Figure C)