Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER USE
1
Unplug the Power Cord, coil it and hang it from the Operator Handle
Grips.
2
Remove the pad holder or brush from the machine. Clean the pad or
brush and hang it up to dry. Allow buffing pads to dry completely before
using again.
Store brushes and pad holders separate from the machine. Never store
the machine with the pad holder or brush on the machine.
3
Wipe the entire machine with a clean, damp cloth. Wipe the underside
of the brush housing after wet use.
4
Inspect the entire machine and all accessories for damage. Perform any
required maintenance or repairs before storage.
5
Store the machine in a clean, dry place with the Handle locked in the
upright position.
TECHNICAL SPECIFICATIONS (AS INSTALLED AND TESTED ON THE UNIT)
Model
Model Number
Motor
Transmission
Pad/Brush Speed
Pad/Brush Size
Wheels
Cord Length
Base Width
Height w/Handle
Net Weight (w/pad holder)
Shipping Weight (w/pad holder)
Construction:
Handle Tube
Upper Handle
Base
TROUBLESHOOTING
SWIRLS ON THE FLOOR AFTER SCRUBBING
•
Floor not clean.
•
Incorrect solution.
•
Area not properly swept - debris in pad or brush.
•
Improper pad or brush for the job.
•
Moving the machine too fast.
SWIRLS ON THE FLOOR AFTER DRY BUFF-
ING
•
Moving the machine too fast.
•
Floor finish too soft.
•
Area not properly swept - debris in pad or brush.
•
Improper pad or brush for the job.
CIRCLES ON THE FLOOR
•
Machine standing still while the brush or pad is running.
FLOOR FINISH REMOVED
•
Improper pad... too aggressive.
•
Solution too strong.
MACHINE WOBBLES DURING OPERATION
•
Defective pad... one side is more dense than the other.
•
Machine left sitting on brush or pad for extended period of time causing
bristles or pad to "take a set".
•
Pad not "seated" properly into pad holder bristles.
•
Warped block on brush or padholder - replace.
MACHINE DOES NOT RUN
•
Check plug for proper connection - on machine and at wall outlet.
•
Check building circuit breaker.
•
Call for service.
SD17
56201706, 56201702 / 56201703
1.50 hp / 1.25 hp
Dual-Planetary
175 rpm
17" (43 cm)
5" (13 cm)
50' (15 m)
18" (46 cm)
47" (120 cm)
86 lbs (39 kg)
90 lbs (41 kg)
Extruded Steel
Injection Molded Nylon
Roto Molded Polyethylene
SD 20
56201707, 56201704 / 56201705
1.50 hp / 1.25 hp
Dual-Planetary
175 rpm
20" (51 cm)
5" (13 cm)
50' (15 m)
20.75" (53 cm)
47" (120 cm)
90 lbs (41 kg)
94 lbs (43 kg)
Extruded Steel
Injection Molded Nylon
Roto Molded Polyethylene
FORM NO. 56041486 / SD 17 / 20 - 7
Publicidad
Tabla de contenido
