SSS Siedle CV 850-1 Guia De Incio Rapido página 5

English
Application
Compact video door station for
surface mounting with 1 or 2 call
buttons. With the basic functions
calling, speech, vision and door
release.
Application
The SET door loudspeaker CV 850-...
is exclusively designed for use within
the SET CV 850-... Any other appli-
cation is deemed not in accordance
with its intended use and exonerates
the manufacturer from any liability.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
The following installation situa-
tions must be avoided without
fail:
• Direct ajour light
• Direct sunlight
• Extremely bright picture back-
ground
• Highly reflective walls on the
opposite side of the door station
• Lamps or direct light sources
Scope of supply
• Door station compact video
CV 850-...
• Siedle screwdriver
• This product information
Mounting
1 Unscrew the front of the housing.
To do this, release the Siedle screw
on the underneath of the housing.
Hinge the front of the housing
forward.
2 Surface mounting the door sta-
tion. Recommended mounting
height appr. 1.50 m /4.9 ft. to centre
device. Please note: The cable is
inserted in the lower area of the
base plate!
3 Strip back the installation cable
close to the wall (appr. 10 mm)
and insert the cores into the base
plate. Fasten the base plate using 4
screws. Close the two openings at
the top using rubber stoppers. Install
in accordance with the terminal
diagram. The cores may only be laid
in the admissible installation space.
4 The pick-up angle of the camera
can be mechanically preadjusted on
the vertical and horizontal by appr.
30° depending on the mounting
situation. To change the pick-up
direction of the camera, it can be
positioned in the required direction.
To change the pick-up direction,
loosen the two cross-head screws
slightly. Position the camera in the
required direction. Then fix the
required position using the two
cross-head screws.
5 Depending on the installation
environment, it may be necessary
to change the door station speech
volume in order to permit clear
speech transmission.
6 Hook the front of the housing
onto the base plate at the top and
close. Tighten the screw on the
underneath of the housing.
Lettering
7 Open the nameplate from the
outside, for example using a flat
bladed screwdriver, and carefully
remove the inscription insert. To
insert the nameplate, lock into place
by exerting light pressure.
Terminal assignment
TaK/TbK In-Home bus: Terminal
to the video set line
rectifier VSNG 850-...
Installation
Installation, commissioning and
programming are described in
the product information sheet for
SET CV 850-... (enclosed with the
Compact Audio SET CA 850-... ).
Specifications
Colour system: PAL
Image pick-up: CMOS sensor
8.4 mm (1/3"), 720 x 480 pixel
(horizontal/vertical)
Lens: 3.7 mm
Pick-up angle: horizontal appr. 60°,
vertical appr. 50°
Additional mechanical adjustment
range: by around 30° (horizontal/
vertical)
Horizontal resolution 500 lines
Integrated LED lighting
2-step heating
Supply: via In-Home bus
Contact type: n.o. contact
15 V AC/30 V DC, 2 A
Ambient temperature:
–20 °C to +40 °C
Protection system: IP 54, IK 8
Dimensions (mm) W x H x D:
82 x 226 x 35
5