Shower Head - Jacuzzi Flexa ELT 4 Manual Uso Y Mantenimiento

Shower head

I Mod. ELT 3-4-8-13-18BT-19BT-20BT
• (fig.1) Turn the knob of the deviator to the symbol for "out-
put from under seat".
• (fig. 2) Turn the lever of the mixer.
If there is a thermostatic mixer tap...
- (fig.3) Turn the stop tap.
- (fig.4) Turn the corresponding knob, so that the reference
notch corresponds to the required temperature; to select tem-
peratures over 38 °C, press the button to release the knob.
• (fig. 5) A jet of water will come out of a nozzle situated un-
der the seat. Test the temperature with a foot; turn the mixer
tap lever (or the knob of the thermostatic mixer)
• (fig. 6) While leaving the mixer open, turn the knob to the indi-
cated symbol. The flow of water under the seat stops and the
system is ready for the start-up of functions via the display.
• To start the function, press on the display the key shown in
fig. 7. You will hear an acoustic signal, the LED near the key
will come on and water will come out of the shower head at
the selected temperature.
• If you press the key again, the function will stop and the cor-
responding LED will go off.
NOTE
This function can be combined with the hot-and-cold show-
er effect (except for version ELT3) by pressing the corre-
sponding key (fig.8). However, always refer to the related
chapter for a more detailed description.
Remember to turn off the mixer tap and position the
diverter to "under seat outlet" (fig.1); if you have a ther-
mostatic mixer, turn the relevant knob to below 38 °C
(fig. 4) and also turn off the stop tap.
1
3
38
5
7
42
2
4
38°
38
6
8