Special Maintenance; In Case Of Difficulty - Jacuzzi Flexa ELT 4 Manual Uso Y Mantenimiento

Occasionally, when just rinsing does not leave it as clean
and bright as you would like, the glass panels can be cleaned
with special scale-remover detergents.
After a period of time, if you should notice that water does
not run off the glass panel so well, you can apply special prod-
ucts that can aid this. Refer to an Authorized Jacuzzi
Centre, however, for this type of maintenance.
Never use abrasive cloths, powder detergents, acetone
or other solvents.

Special maintenance

I Any unscheduled maintenance work, for example on the
electromechanical parts on the back of the fitted-out wall, or
scratches and stains on acrylic parts, are to be handled ex-
clusively by specialized personnel.
In such cases, contact only an Authorized Jacuzzi
Centre.
In the event of difficulty...
I SYMPTOM
Solution
I NO WATER IS SUPPLIED FROM FUNCTIONS (SHOW-
ER, CASCADE, HYDROMASSAGE, ETC.)
Turn on the mixer tap.
I DISPLAY OFF.
Place the main switch in the ON position (see installation
manual).
I THE SHOWER PROVIDES INADEQUATE PRESSURE.
Clean the shower filter.
I LITTLE WATER IS DISPENSED IN ALL FUNCTIONS.
Check that the installer has complied with the pressure/flow
rate conditions set forth on the installation manual. For wa-
ter that is hard or contains a lot of impurities, or after inten-
sive use of the shower box, you may need to have the filters
of the solenoid valves cleaned (call technical service). If the
shower box is equipped with a thermostatic mixer, its filter
may be clogged with dirt and/or lime scale.
I THE HYDROMASSAGE PROVIDES INADEQUATE
PRESSURE.
Clean the nozzles. If this does not suffice, call technical ser-
vice (for cleaning of solenoid valve filter and/or verification
of mains pressure/flow rate).
I DIFFICULT TO ADJUST THE WATER TEMPERATURE
(MIXING)
Check that the pressure values of the system (operating) for
hot and cold water are well-balanced. If the values are dif-
ferent, it is advisable to contact your entrusted plumber.
® Service
I ONCE THE TURKISH BATH FUNCTION HAS BEEN
SET, ITS LED CONTINUES TO FLASH AND THE FUNC-
TION DOES NOT WORK.
Check that the mixer is open and/or check that the water sup-
ply from the mains has not been interrupted. If the problem per-
sists, shut the system off and contact technical service.
I THE TURKISH BATH FUNCTION IS ACTIVE BUT
STEAM DOES NOT COME OUT OF THE OUTLETS.
Safety thermostat has probably tripped. Call technical service.
I THE DISPLAY IS ON BUT IT DOES NOT RECEIVE
® Service
THE PROGRAMMES
Shut the system off and contact technical service.
59