Power Fall" Waterfall - Jacuzzi Flexa ELT 4 Manual Uso Y Mantenimiento

Ocultar thumbs Ver también para Flexa ELT 4:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

"Power Fall" cascade
This function lets you enjoy a vigorous, energizing massage.
The water comes out of an opening from above, hidden by
a door with the Jacuzzi trademark.
• Check that the latch is raised (discharge open), or if neces-
sary raise it using the knob on the edge of the tray (fig.1). Ex-
tract the latch from the drain pipe, clean it carefully (hair, etc.)
and put it back in place.
• Adjust the water temperature and set up the function as in-
dicated in the chapter on the "Shower" function (fig. 2). You
you have adjusted the water to the right value, lower the latch
and leave the mixer open. In this way the main drain will close
(fig.1).
• (fig. 1) Let the tray fill up to the level indicated by the two
notches (see arrows) located under the seat; then close the
mixer (fig. 3).
The shower tray has an overflow outlet, located just above the
two level notches.
Do not leave the mixer open after the required water
level has been reached.
• You can now start the "Power Fall" cascade. When you press
the corresponding key on the display (fig. 4), the correspond-
ing LED comes on, the pump starts up and water comes out
of the opening located above (fig. 5) (if it is closed, the door
is opened by the jet of water).
• If you press the key again, the function will stop and the cor-
responding LED will go off.
• When treatment is complete, turn the knob on the edge of
the tray to raise the latch and drain the water.
• Remember to close the door with the Jacuzzi trademark on it.
The described function includes a safety feature. It cannot
be started if water has not been filled, or if water is at a low-
er level than required.
While not recommended, and in a certain sense illogical,
during the "Power Fall" cascade you can activate any other
shower box function, except for the Turkish bath.
During the cascade function, if you press the key that cor-
responds to the Turkish bath, the display will accept the com-
mand and the electronic cycle is activated (including the
time countdown), but there will be no steam production as
long as the "Power Fall" cascade is active, because the steam
generator remains disconnected (safeguard against exces-
sive consumption).
Contrarily, if during the Turkish bath the "Power Fall" cas-
cade is activated (obviously after filling the tray with water)
the steam generator is immediately disconnected (steam pro-
ductions stops), even if the electronic cycle on the display
continues.
When the cascade is shut off, the steam generator is auto-
matically reactivated (if the time for Turkish bath operation
has not expired).
1
2
4
5
44
3

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido