Alarm; Clock - Jacuzzi Flexa ELT 4 Manual Uso Y Mantenimiento

Alarm

Connection to the alarm circuit must be made during in-
stallation, by qualified personnel, in compliance with the in-
structions set forth in the installation manual.
• (fig. 1) Any alarm signal (beepers, buzzers, flashing lights,
etc.) is automatically activated when the corresponding key is
pressed (if the display is on). The alarm signal, shown on the
display by the flashing message "ALL", lasts about 15 sec-
onds, after which it stops automatically.
• If this key is pressed by accident, you can press it again to
stop the alarm function immediately.
• When the alarm is activated, the function currently in progress
is immediately interrupted (except for manual functions and
the scale removal cycle) and does not start again when the
alarm stops. This happens even if the shower box is not con-
nected to the alarm circuit.

Clock

This function allows you to view the current time. The val-
ues (set in the factory) that you will find the first time you
use the clock are random. If you want to set or adjust the
time, do the following:
• (fig. 1) Press the "clock" key. The two digits for the minutes
will start flashing. This value can now be changed using the
keys "+" or "-".
• Press the "clock" key again (within about 6 seconds). The
digits for the hours will now flash. Also in this case, to make
modifications, use the keys"+" or "-".
• Press the "clock" key a third time (within about 6 seconds).
The set value is memorized and the figures on the display will
stop flashing.
NOTE
If you press any function key prior to final memorization, the
newly set time will be cancelled. You will therefore need to
repeat the described operations.
1
1
51
1
2