Start Up; Rotation Direction - Truper TPN-886H-2 Manual Del Usuario

Air Inlet Connection
• Add two or three drops lubricant with no detergent (A)
to the air inlet (B) before each use.
• Screw the fast connector (C, not included) to the air
inlet.
• Connect the air hose with a fast couple (D, not
included) to the fast adaptor.

Rotation Direction

• The rotation direction relies in the direction towards the
selector turns (F).
• To tighten one nut or lug, turn the selector to the right
to make the die turn in a clockwise direction, to loosen,
turn the selector to the left so that the die turns in a
counter clockwise direction.
• The torque value may vary depending of the size of the
air compressor and the amount of square feet (CFM) air it
delivers.
Turning ON
• Turn on the air compressor until is full.
• Regulate output pressure of the air compressor to
90 PSI
The tool operates at this pressure level.
WARNING
if operated at higher levels, the useful life of the tool will
decrease.
• Allow some air to flow through the hose and the couple
to verify both are clean before connecting to the tool.
• Determine the right rotation direction.
• Press the action trigger (G) to start the die.
• Stop pressuring the action trigger to stop the die.
Operation
• Set the die in the nut or lug to tighten or loosen.
• Before operating the tool make sure there is enough
space behind the tool to prevent trapping your hand. The
tool travels away from the nut / screw when it is loosened
or tightened.
• Do not try to make contact with the nut or lug when the
die is moving. Do not press the trigger unless the nut or
lug is duly inside the die.
• Apply firm and constant pressure but not forcing the
tool. Otherwise, it gets damaged.
8
ENGLISH

Start Up

A
D
C
B
F
G