Introduction; Storage; Product Disposal; Transport - EBARA 2SP EFC 1,5T-1 Instrucciones Para La Instalación Y El Mantenimiento

2. INTRODUCTION

This documentation provides general indications for the storage, installation and use of the electric panels listed in
this handbook. The devices have been designed and made to control and protect centrifugal surface electric pumps
installed in pressure booster sets with one, two and three pumps for domestic and industrial applications.

3. STORAGE

A long period of inactivity in precarious storage conditions may cause damage to the equipment and thus cause
risk to the personnel in charge of installation, control and maintenance.
First of all it is good practice to ensure that the control panel is correctly stored, scrupulously observing the
following indications:
- the set must be kept in a completely dry place, far from sources of heat;
- electric panel must be perfectly closed and insulated from the outside environment, so as to prevent insects,
damp and dust from getting in and damaging the electric components, to the detriment of their regular
operation.

3.1 PRODUCT DISPOSAL

This symbol on the product indicates that the panel can not be disposed of with household waste.
This provision only concerns the disposal of equipment in the territory of the Union
European (2012/19 / EU).
It is the user's responsibility to dispose of electrical equipment at designated collection points
disposal and recycling of electrical equipment or contact the store where it was
purchased the product .

4. TRANSPORT

Avoid subjecting the products to needless jolts or collisions.

5. WARNINGS

5.1 Read this documentation carefully before installation.
It is indispensable to have the electric system and connections made by skilled personnel, in possession
of the technical qualifications indicated by the safety standards concerning the design, installation and
maintenance of technical plants, in force in the country where the product is to be installed.
Failure to comply with the safety regulations not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
5.2 The term skilled personnel means persons whose training, experience and instruction, as well as their
knowledge of the respective standards and requirements for accident prevention and working
conditions, have been approved by the person in charge of plant safety, authorising them to perform all
the necessary activities, during which they are able to recognise and avoid all dangers. (Definition for
technical personnel IEC 364)
5.3 Check that no damage has been done to the panel and set during transport or storage. In particular,
ensure that the external casing is perfectly entire and in excellent condition; all the internal parts of the
panel (components, leads, etc.) must be completely free from traces of damp, oxide or dirt. Clean
carefully and check the efficiency of all the components in the panel; if necessary, replace any parts that
are not perfectly efficient It is indispensable to ensure that all the leads in the panel are correctly
secured to their terminals. In the event of long storage (or in the event of replacement of any part) it is
advisable to carry out on the panel all the tests indicated by standards EN 60204-1.
5.4 Before switching electrical panel from power supply, set pumps selectors SA1,SA2,SA3,SA4,SA5 in OFF
position.
Do not switch electrical panel more than 2 times in a minute.
6. RESPONSIBILITY
The Manufacturer does not ensure good operation of the panel if it is tampered with or modified or made
to operate at values beyond the data on the plate.
The Manufacturer also declines all responsibility for possible errors in this booklet, if due to misprints or
errors incopying. The company reserves the right to make any modifications to products that it may
consider necessary or useful, without affecting the essential characteristics.
ENGLISH
21