Recording Emergency Button Identification Announcements - Clarity The Talking Phone JV35 Manual Del Usuario

Operating your JV35
7. To change a stored number
or to program another
memory button, repeat this
process from step 1.
J. MEM Dialing
1. Lift the handset.
2. Press MEM and one of
the number buttons.
MEM PROG
TONE Lo Hi
Fig. 21- Memory Button
You will hear an
announcement such as
"Memory One" and then
the number you have stored for
that button will be automatically
dialed.
12
FLASH REDIAL
BOOST
VOL
K. Recording Emergency
Button Identification
Announcements
The JV35 comes with factory
pre-recorded announcements to
identify each Emergency button
such as "Emergency One," etc. You
can erase these identification
announcements and record
announcements of your own, such
as "Police" or "Fire" by following
these steps:
1. Slide the
ANNOUNCEMENT
switch to the PROG
position.
2. Pick up the handset. You
will hear "Program Mode,
Program Mode"
followed by a "beep-
beep" sound. This
confirms the JV35 is
ready to be programmed.