Fisher&Paykel myAIRVO 2 Manual De Usuario página 10

4. SELECT PATIENT INTERFACE
The myAIRVO 2 can be used with a variety of patient interfaces. Read the separate user instructions for
the patient interface that will be used, including all warnings.
WARNINGS
To avoid burns:
• Do not modify the breathing tube or interface in any way.
• Do not use any patient interfaces not listed here.
Nasal cannula
Optiflow™+ Optiflow™
OPT942E OPT842E
OPT944E OPT844E
OPT946E OPT846E
All patient interfaces are Type BF applied parts.
The following table shows the target dew-point temperature settings and target flow settings able to be
used with these interfaces.
Patient Interface
Low temperature ambient conditions may prevent the unit from reaching a 37 °C target temperature
setting at high target flow settings. In these cases, consider decreasing the target flow setting.
At altitude, the maximum flow rates achievable may be lower than those in the above table, by
approximately 5 L/min per 1000 m (3000 ft).
Optiflow™ Junior/
OPT316/OPT318
(Refer to "Using AIRVO 2" -
"Junior Mode")
2
OPT942
OPT316
2
OPT944 OPT318
OPT946 OPT942E
OPT944E
OPT870
RT013 OPT946E
OPT970E
OPT980E
OPT842E
OPT844E
OPT846E
OPT870E
RT013E
A – 6
Tracheostomy
interface
OPT970E / OPT980E / RT013E (with mask)
OPT870E
Note that
Interface Adapter is designed to be used with
vented masks only. Do not use sealed masks.
10
10
10
10
10
10
10
10
10
10
Mask interface
adapter
the OPT980E/RT013E Mask