Using Myairvo 2 - Fisher&Paykel myAIRVO 2 Manual De Usuario

3. USING myAIRVO 2

1. SWITCH ON UNIT
Plug the unit's power cord into the mains/utility power socket. The
connector at the other end of the power cord should be well secured to
the rear of the unit.
WARNINGS
To avoid electric shock:
• Ensure that the unit is dry before plugging into the mains/utility power socket.
Switch on the unit by pressing the On/Off button for 5 seconds.
2. WARM-UP
The unit will begin to warm up. You will see a warm-up symbol on the
screen.
"Warm-up" symbol
3. CONNECT THE PATIENT INTERFACE
"Ready for use" symbol
When the "Ready for Use" symbol appears on the display, connect the
patient interface to the heated breathing tube. When you first use the
unit, the air will feel warm. Continue to breathe normally.
4. AFTER USE
When you have finished using the unit, remove your interface and drain
any excess condensate in the breathing tube by lifting the patient end
of the tube, and allowing the condensate to run into the water chamber.
5. DRYING MODE
Then press and hold the On/Off button for 3 seconds until a melody
sounds. The unit will automatically enter Drying Mode and dry the tube
so it is ready for you to use next time. Drying Mode runs for 99 minutes.
The unit will automatically turn off when it is finished.
WARNINGS
To avoid burns:
• Do not wear the interface during Drying Mode. The air is hot and dry and may
cause injury.
• Do not remove the water chamber until drying mode has been completed.
To switch the unit off without completing Drying Mode (this is not
recommended), hold down the On/Off button for 5 seconds.
If you unplug the unit's power cord from the mains/utility power socket
while the unit is still running, the "Power Out" alarm will sound. Press
the "Audio Pause" button to silence this alarm.
A – 7