Inserting A Battery Pack; External Devices - Orion QuikRead go Instrucciones De Uso

Inserting a battery pack

Follow the steps below to insert a battery pack into
the QuikRead go instrument.
1. Make sure the instrument is turned off
2. Unplug the power-supply cable
3. Place the instrument on its side on a table
4. Open the battery compartment, removing the
cover
5. Attach the battery connector to the battery pack
6. Press the battery pack into place and ensure
that it is positioned properly
7. Attach the battery-compartment cover
8. Place the instrument back in the upright, opera-
tion position

External devices

Barcode reader
An external barcode reader can be connected
to the QuikRead go instrument. A list of com-
patible barcode reader devices can be found via
www.quikread.com.
Connect the compatible barcode reader to a USB
port and follow the instructions on the display.
Printer
The instrument can be connected to an external
printer. A list of compatible printers and configu-
ration parameters can be found on the QuikRead
website, www.quikread.com.
Connect the compatible printer to a USB port and
follow the instructions on the display.
10
INSTALLATION PROCEDURES AND REQUIREMENTS
1
Image 8
1. Battery-compartment cover
2. Battery-pack connector
3. Battery pack
4. Clock battery
2 4
3