Power cable and battery pack
The QuikRead go instrument can be used with either
the power-supply cable or an optional battery pack.
The battery pack is charged automatically when the
power cable is plugged in.
USB
RJ-45
Consult instructions
for use
Constant force,
motion or flow
On-Off switch
Image 6
Symbols on QuikRead go
Connectors and cables
On the back of the instrument are five connection
slots, with symbols describing their use. One USB
port can be found on the right side of the instru-
ment. All of the symbols are described in Image 6.
The RJ45 connector can be used for serial and LAN
connections.
Image 7
Connection of the power supply cable
Plugging in the power supply cable
Plug in the power-supply cable, using the marked
connection at the back of the instrument. Plug in
the other end of the cable to a power outlet.
INSTALLATION PROCEDURES AND REQUIREMENTS
9