Tools & Parts; Tools Needed; Parts Supplied - Maytag MDE28PD Instrucciones De Instalación

TOOLS & PARTS

Tools Needed:

203 mm (8")
or 254 mm (10")
Pipe wrench
Torx T20 Security
®†
screwdriver or bit
Level
Caulk gun and caulk
(for installing new exhaust vent)
Flashlight (optional)

Parts Supplied:

n Foot boots (4)
n Leveling legs (4)
n PN models: Card reader bezel, hardware
NOTE: The circuit diagram for this dryer is located inside the lower front panel, within the Tech Sheets.
Technical Specifications:
220–240 V, 50 HZ. 10A
Total mass: 68 kg max.
NOISE: Sound Pressure Level, Lpa: 58 dBA (uncertainty,
Kpa: +/–10 dBA).
†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
6
203 mm (8") or 254 mm (10")
Adjustable wrench
that opens to 25 mm (1")
25 mm (1") Hex-head
socket wrench
Utility knife
Vent clamps
25 mm (1")
Open-end wrenches
Flat-blade screwdriver
8 mm (5/16") Socket wrench
6 mm (1/4") Nut driver
Pipe-joint compound
suitable for gas type
Ruler or measuring tape
Phillips screwdriver
Pliers
(that open to 39 mm [1 /
9
16
Locking pliers
686 mm (27") Wood block
Putty knife
"])