Tools & Parts; Tools Needed; Parts Supplied - Maytag MDG25PN Instrucciones De Instalación

TOOLS & PARTS

Tools Needed:

203 mm (8") 203 mm (8") or 254 mm (10") Flat-blade screwdriver Phillips screwdriver
or 254 mm (10") Adjustable wrench
Pipe wrench that opens to 25 mm (1")
Torx T20 Security 25 mm (1") Hex-head 8 mm (5/16") Socket wrench Pliers
®†
screwdriver or bit socket wrench (that open to 39 mm [1 / "])
9
16
Level Utility knife 6 mm (1/4") Nut driver Locking pliers
Caulk gun and caulk Vent clamps Pipe-joint compound 686 mm (27") Wood block
(for installing new exhaust vent) suitable for gas type
Flashlight (optional) 13 mm (1/2") and 14 mm Ruler or measuring tape Putty knife
(9/16") Open-end wrenches

Parts Supplied:

Foot boots (4) Leveling legs (4) PD models: Cam for service PN models: Card reader
door lock bezel, card reader wire
harness, hardware
NOTE: The circuit diagram for this dryer is located inside the lower front panel, within the Tech Sheets.
†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
7