Tools Needed:
203 mm (8")
or 254 mm (10")
Pipe Wrench
Torx
T-20
Security
®†
®†
Screwdriver or Bit
Level
Caulk Gun and Caulk
(for installing new exhaust vent)
Flashlight (optional)
Parts Supplied:
Foot Boots (4)
NOTE: The circuit diagram for this dryer is located inside the lower
front panel, within the Tech Sheets.
Technical Specifications:
220 – 240 V, 50 Hz. AC
4575W
Total mass: 68 kg max.
NOTE: Sound Pressure Level, Lpa: 58 dBA
(uncertainty, Kpa: +/–10 dBA).
†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
203 mm (8") or 254 mm (10")
Adjustable Wrench
that opens to 25 mm ( 1")
25 mm (1") Hex-Head
Socket Wrench
Utility Knife
Vent Clamps
25 mm (1")
Open-End Wrenches
Leveling Legs (4)
Clothes Capacity:
Dry Linen Capacity
10.5 kg
IEC Capacity
9 kg
Flat-Blade Screwdriver
8 mm ( 5⁄16") Socket Wrench
6 mm (1/4") Nut Driver
Pipe-Joint Compound
Suitable for Gas Type
Ruler or Measuring Tape
Security Cone
TOOLS & PARTS
Phillips Screwdriver
Pliers (that open to
39 mm [1
/
"])
9
16
686 mm (27")
Wood Block
Putty Knife
5/16" Hex Head – 18 x 2
Security Bolt
⁄
"
1
2
7