Parameters; First Level - Frequent Parameters; Second Level - Configuration Parameters; Modifying And Saving The Parameters - Carel MasterCella compact Manual De Utilización

4. Parameters

The parameters have been organised into two levels.
4.1 First level: frequent parameters (F)
They are indicated with F in the table and the password is not necessary to gain access to them. To modify
them operate as follows:
1. press the button for about 5 seconds (in case of alarm, first silence the buzzer);
prg
2. the display shows the code of the first parameter to be modified.
To modify the parameters see the Modifying and saving the parameters section.
4.2 Second level: configuration parameters (C)
They are indicated with C in the table and it is necessary to insert the password for any modification, as
indicated here below:
1. press simultaneously the
2. the display shows 00;
3. press the or
4. confirm by pressing
5. the display shows the code of the first parameter to be modified.
To modify the parameters see the following section, Modifying and saving the parameters.

4.3 Modifying and saving the parameters

4.3.1 Modifying

After having entered the configuration level, to modify a parameter operate as follows:
a. press and/or
SET
b. press the button to visualise the value associated to the parameter;
c. modify its value by pressing the
SET
d. press the button to temporarily confirm the newly set value and to go back to the param. code display;
e. repeat all operations from the point "press
Per memorizzare passare a "Saving".

4.3.2 Saving

To store the new set values of the parameters:
1. Press the button to store definitively all the new set values and exit the procedure.
prg
2. It is possible to exit without modifying parameters: do not press any button for at least 60 seconds (TIME
OUT exit).
3. If the button
prg
the starting values will be restored.
SET
and
prg
button until 22 (password) is displayed;
SET
button;
until the parameter to be modified is displayed (refer to the parameters table);
and/or
is not pressed after modifying operations, all the effected variations will be lost, and
buttons for about 5 seconds;
" buttons until the desired value is displayed;
and/or " to modify other parameters values.
29