Nuova Simonelli MICROBAR Instrucciones De Manejo página 67

EN
• Press the ENTER key;
• The machine will begin to suck up the solution
from the tank and at the same time, to expel hot
water from the nozzle.
• The machine display will read as follows:
Once it has sucked up the first litre of solution, the
machine will stop for five minutes and then it will start
to suck up another litre of solution.
• At the end of this cycle, the display will read as
follows:
• Rinse out the tank and refill it with clean water
(without switch off the machine).
NOTE: Use at least 4 litres (1.06 gal) of solution,
otherwise it will be necessary to restart the
cycle.
• Wait at least 5 minutes.
• At the end of this time, the display will read:
• Press the ENTER key and the machine will begin
a rinse cycle, taking on board 2 litres (0,53 gal)
of water from the container and then expelling it
through the steam nozzle.
• During this stage, the machine display will read as
follows:
• When the machine has finished the 2 litres (0,53
gal) taken from the container, the display will again
read:
Press the ENTER key again for the machine to start
the second stage of the rinse cycle, taking a further
2 litres(0,53 gal) on board from the container. The
machine display will then read:
• At the end of the rinse cycle, the machine display
will read as follows:
Leave the machine to heat up for a few minutes; at
the end of this time, the machine will return to its
ready status.
WARNING
We advise using the steam dispensing function
for a few minutes at the end of each de-scaling
cycle.
You may notice drops of water and steam
coming from the hot water nozzle during the
heating stage.
WARNING
65