Machine Installation - Nuova Simonelli MICROBAR Instrucciones De Manejo

4. INSTALLATION
AND PRELIMINARY
OPERATIONS
RISK OF POLLUTION
Do not dispose of packaging in the environment
Before carrying out any installation and
adjustment operations you must read and fully
understand the SAFETY INSTRUCTIONS of this
handbook. The company cannot be held respon-
sible for damage to things or injury to persons
caused by failure to comply with the safety
instructions and installation and maintenance
instructions contained in this handbook.
Place the machine on a flat, level surface to avoid
any possible malfunctioning.
Never install the machine in areas where it could
come into contact with jets of water.
The machine can be used with the following:
- Coffee grains
- Decaffeinated coffee powder
- Milk (not powdered)
The use of any other substance not listed here
above may cause serious damage to the machi-
ne itself.
The machine is designed to operate at tempera-
tures ranging from +5°C to +40°C (41°F - 104°F).
48
CAUTION
Fig. 15
WARNING
WARNING
WARNING
WARNING
RISK OF SHORT CIRCUITS
Before connecting the machine to the mains
power supply, please check that the supply vol-
tage corresponds to the machine voltage.
NOTE: At the start of the day's activities and in any
case, if there are any pauses of more than 8
hours, then it is necessary to change 100%
of the water in the circuits, using the relevant
dispensers.
NOTE: In case of use where service is continuous,
make the above changes at least once a
week.
4.1 MACHINE
INSTALLATION
(VERSION WITH TANK)
Switch off the machine before filling or removing
the water tank.
Once the machine has been withdrawn from the
packaging, carry out the following instructions:
1 Position the unit on a horizontal surface.
2 Open the hatch.
3 Withdraw the water tank by pulling it upwards.
4 Particularly the first time, wash the tank with soapy
water and then carefully rinse off all soap.
5 Fill the water tank with water.
6 Make sure that the outside of the water tank is dry.
7 Return the water tank to its site.
CAUTION
WARNING
Fig. 16
EN