Commissioning The Pegase Vma 20 Pc Parameter Software; Installation; Installing The Software; Software Installation - Leroy-Somer VARMECA-20 Instrucciones De Parametrización

LEROY-SOMER

COMMISSIONING THE PEGASE VMA 20 PC PARAMETER SOFTWARE

3 - COMMISSIONING THE PEGASE
VMA 20 PC PARAMETER
SOFTWARE

3.1 - Installation

3.1.1 - Checks on receipt
When you receive your parameter setting kit, make sure that
it has not been damaged during transport. Should damage
have occurred, please report it to those responsible for its
transport.
3.1.2 - Minimum PC configuration
Pentium 100 MHz
Windows 95 - 98
32 Mb memory
30 Mb disk space
3.1.3 - Connection
- Open the front cover of the VARMECA 20.
- Connect the 4-pin socket at the end of the cable to the
connector located on the VARMECA 20 connection card
(P3 connector).
- The cable SUB-D socket is then connected to the PC SUB-D
socket.
54
PARAMETER SETTING MANUAL
VARMECA 20
Variable speed motors and geared motors

3.2 - Software installation

- Insert the CD in the drive
- After a few seconds the following window appears:
Click here for installation then
follow the instructions
During installation, the program suggests a destination
directory. If you are happy with this suggestion, click "Next" to
end installation (see page below).
If you wish to install PEGASE VARMECA in a different
directory, click "Browse" to select another destination
directory. Once you have made your choice, click "Next" to
end installation.
3532 - 05.2004 / f