Connection Panel (Pdp-60Mxe20) - Pioneer PDP-60MXE20 Guia De Inicio Rapido

Connection panel (PDP-60MXE20)

The connection panel is provided with two video input
terminals and one video output terminal. Audio input/
output and speaker output terminals are also provided.
1
COMBINATION IN/OUT
Never connect any component to these
connectors without first consulting your Pioneer
installation technician.
These connectors are used for Plasma Display setup
adjustments.
2
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker that has an impedance of 6 Ω to
16 Ω.
3
SPEAKER (L) terminal
For connection of an external left speaker. Connect a
speaker that has an impedance of 6 Ω to 16 Ω.
4
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for Plasma Display setup
adjustments.
5
AUDIO (OUTPUT) (Stereo mini jack)
Use to output the audio of the selected source
component connected to this unit to an AV amplifier
or similar component.
Note: No sound is produced from the AUDIO (OUTPUT) jack
when the MAIN POWER switch is set to OFF or ON (standby).
6
AUDIO (INPUT1) (Stereo mini jack)
Use to obtain sound when INPUT1 is selected.
Connect the audio output jack of components
connected to INPUT1 to this unit.
IN OUT
RS-232C
COMBINATION
1 2 3 4
Part Names and Functions
-
OUTPUT INPUT1 INPUT2 INPUT1
ANALOG RGB OUT ANALOG RGB IN
(D-Sub) (D-Sub)
AUDIO AUDIO AUDIO
5 67 8 9
7
AUDIO (INPUT2) (Stereo mini jack)
Use to obtain sound when INPUT2 is selected.
Connect the audio output jack of components
connected to INPUT2 to this unit.
8
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) terminal to
output the video signal to an external monitor or other
component.
Note: The video signal will not be output from the ANALOG
RGB OUT (INPUT1) terminal when the main power of this
unit is off or in standby mode.
9
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connection of a personal computer (PC) or similar
component. Make sure that the connection made
corresponds to the format of the signal output from
the connected component.
0
DIGITAL RGB (INPUT2) (DVI-D jack)
Use to connect a computer.
-
AC IN
Use to connect the supplied power cord to an AC
outlet.
=
MAIN POWER switch
Use to switch the main power of the unit on and off.
=
INPUT2
DIGITAL RGB
(DVI-D)
0
7
En