How To Route Cables - Pioneer PDP-60MXE20 Guia De Inicio Rapido

How to route cables

Speed clamps are included with this unit for bunching
cables together. Once components are connected, follow
the following steps to route cables.
1
Organize cables together using the provided
speed clamps.
Insert 1 into an appropriate hole on the rear of the
unit, then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo
once in place. Please attach carefully.
To attach the speed clamps to the main unit
Connect the speed clamps using the 4 holes marked with "‡" below, depending on the situation.
Use the holes marked with the & sign as needed.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over
time and may get damaged when removed.
1 2
PDP-50MXE20/PDP-50MXE20-S
Installation and Connections
* As viewed from the rear of the display.
2
Bunch separated cables together and secure them
with the provided bead bands.
Do not allow excessive stress to be placed on the
ends of cables.
Note
Cables can be routed to the right or left.
* As viewed from the rear of the display.
PDP-60MXE20
PDP-42MXE20
13
En