Replacement Parts And Accessories - Hach 5500 Serie Manual Del Usuario

Table 7 Event list for dissolved oxygen sensors (continued)
Event Description
CAL FAIL The calibration failed
DO LOW The measurement is below the lower limit
CAL HIGH The calibration value is above the upper limit
UNSTABLE The reading during calibration was unstable
CHANGE IN CONFIG float The configuration was changed—floating point type
CHANGE IN CONFIG text The configuration was changed—text type
CHANGE IN CONFIG int The configuration was changed—integer value type
RESET CONFIG The configuration was reset to the default options
ADC FAILURE The ADC conversion failed (hardware failure)
FLASH ERASE The external serial flash memory erase occurred
TEMPERATURE The temperature is out of range (0 to 50 °C)
TEMP CAL START Start of temperature calibration
TEMP CAL END End of temperature calibration
AIR CAL START Start of air calibration
AIR CAL END End of air calibration
SAMPLE CAL START Start of calibration
SAMPLE CAL END End of calibration
SAT CAL START Start of saturation calibration
SAT CAL END End of saturation calibration

Replacement parts and accessories

Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
18 English
Description
Calibration bags, disposable
®
O-ring, Viton , for sensor cartridge
Protector cap
Retaining cap
Sensor cartridge (includes O-ring)
Quantity Item no.
pkg/12 276M1210
each 5H0675
each 5500F1008-003
each 5500F1018-003
each 5500A1020-001