Schubert SR1 Manual De Instrucciones página 22

D. the helmet
2. Apply light pressure directed
towards the helmet and a closing
motion until the visor engages
audibly.
3. Check the functioning of the Face
Shield mechanism by opening it
until it hits the end stop and then
closing it again.
REPLACEMENT FACE SHIELD WITH PINLOCK
Fitting
1. Lay the replacement lense in the
Face Shield in such a way that one
side of it is already slotted into the
locking pin and the silicone seal is
on the side facing the Face Shield.
2. Now grasp the other side of the
replacement lense by its upper and
lower transverse edges and use
your index finger to gently press
the end of the visor into a slight
'S' shape. Now you can easily guide
the slot over the locking pin and
release the replacement lense into
place.
22
®
-LENSE