Safety Note - Schubert SR1 Manual De Instrucciones

Note:
In view of the strong air pressure acting on the silicone seal
when travelling with an open face schield, we recommend
riding with a closed face schield at all times to prevent any
dirt or moisture from getting inside the helmet.
Note:
Never press the locking pins out with your fingers as they may
break.
Caution:
As a result of the double shield lens structure, there is a
possibility of greater light reflection in the face schield,
especially when riding at night. As a rule, such light reflection
is regarded as uncritical due to the absence of misting with this
type of shield. However, if this light reflection should cause you
difficulties - because of particular sensitivity to it, for example -
you should refrain from using the replacement lense.
Caution:
If moisture is present in or has penetrated the airtight area
between the two plates, you should remove the replacement
lense immediately in order to prevent any interference with
visibility. Do not re-fit it until both plates are completely
dry (we recommend air-drying). If you should subsequently
detect any further penetration of moisture, the replacement
lense should not be used on any account and must be
replaced.

Safety note

Check before each journey that the Face Shield and sun visor
mechanism are functioning correctly and that the Face Shield and
sun visor will provide good visibility. Any dirt should be removed
before setting off. Check the Face Shield and sun visor for physical
damage and cracks. Severely scratched or matt Face Shields will
seriously impair visibility and should be replaced before setting
off on a journey.
25