Schubert SR1 Manual De Instrucciones página 24

D. the helmet
Removal
1. Before starting to remove the
replacement lense, first lay the
Face Shield on a soft, clean cloth
so that its top edge is facing you.
2. To reduce the pretensioning of
®
the Pinlock -lense slightly if
necessary, use the balls of your
thumbs to carefully bend the
Face Shield sufficiently apart
while applying pressure with your
thumbs to release the replacement
lense and move it approx. 2 - 3 mm
forward.
3. Now grip the back of the
replacement lense with your
index and middle fingers and
lift it off the Face Shield. In this
position you can easily remove
the replacement lense from the
locking pin with your thumb.
4. You can now remove the
replacement lense from the
Face Shield.
Note:
• to avoid scratching the face schield, never remove or fit the
replacement lense unless the visor unit is clean and dry.
• When fitting the replacement lense, check that neither
dust nor moisture are able to get between the two plates.
• When removing or fitting the replacement lense, it is always
best to lay the face schield unit on a clean, dry cloth.
• Check regularly to ensure that the fit of the silicone seal
between the Face Shield and the Pinlock
and even.
24
® -lense is tight