Charge The Battery - Fluke 1550C Manual Del Usurario

Charge the Battery

This Tester uses a rechargeable 12 V lead-acid battery for power. Do
not mix with the solid waste stream. Use a qualified recycler or
hazardous materials handler to discard dead batteries. Contact your
approved Fluke Service Center for disposal and recycling data.
Storing rechargeable lead-acid batteries in a low-charged state could
decrease their life and/or damage them. Fully charge the battery
before storing it for extended periods and examine the charge at
regular intervals.
Charge the 12 V lead-acid battery with the ac power cord.
12 hours is typically necessary to fully charge the battery. Do not charge in
very high or low temperatures. Charge the battery if the Tester is not used for
extended periods. Figure 5 shows how to connect the Tester to a power supply.
Safety Shutter
Pb
Figure 5. Power Supply Connections.
=
Note
Insulation Tester
The Tester
GHH11.EPS
11