View Results Stored In Memory - Fluke 1550C Manual Del Usurario

View Results Stored in Memory

Parameters not appropriate for a test are shown as INVALID.
The Tester can store 99 sets of test data, including:
•
Tags
•
Ramp on or off
•
Insulation Resistance
•
Timer reading at termination of test (Timer)
•
Test Voltage Selected (TV)
•
Actual Test voltage (V)
•
Capacitance I
•
Polarization Index (PI)
•
Dielectric absorption ratio (DAR)
•
Test current (I)
•
Reason for ending the test
•
Limit – off or timer setting (1 to 99 minutes) (T. Limit)
To view stored test data, see Figure 11:
1. With the Tester turned on, push  to call the Function menu.
2. Push  or  to select 3. Show Results.
3. Push  to select the menu item.
When a voltage is present at the terminals, that voltage is always
shown on the top-center of the display, regardless of whether that
voltage is sourced by the Tester or is from the circuit under test.
Note
Note
Insulation Tester
Measurements
23