Threadlockers And Sealants - Wacker Neuson BS 50 Manual De Reparaciones

Threadlockers and Sealants

TYPE
( ) = Europe
Loctite 222
Hernon 420
Omnifit 1150 (50M)
Hernon 423
Omnifit 1350 (100M)
Loctite 271/277
Hernon 427
Omnifit 1550 (220M)
Loctite 290
Hernon 431
Omnifit 1710 (230LL)
Loctite 609
Hernon 822
Omnifit 1730 (230L)
Loctite 545
Hernon 947
Omnifit 1150 (50M)
Loctite 592
Hernon 920
Omnifit 790
Loctite 515
Hernon 910
Omnifit 10
Loctite 496
Hernon 110
Omnifit Sicomet 7000
Threadlocking adhesives and sealants are specified throughout this
manual by a notation of "S" plus a number (S#) and should be used
where indicated. Threadlocking compounds normally break down at
temperatures above 175°C (350°F). If a screw or bolt is hard to
remove, heat it using a small propane torch to break down the sealant.
When applying sealants, follow instructions on container. The sealants
listed below are recommended for use on Wacker equipment.
COLOR USAGE
Purple Low strength, for locking threads smaller than 6 mm
(1/4").
Hand tool removable.
Temp. range, -54 to 149°C (-65 to 300°F)
Blue Medium strength, for locking threads larger than
6 mm (1/4").
Hand tool removable.
Temp. range, -54 to 149°C (-65 to 300°F)
Red High strength, for all threads up to 25 mm (1").
Heat parts before disassembly.
Temp. range, -54 to 149°C (-65 to 300°F)
Green Medium to high strength, for locking preassembled
threads and for sealing weld porosity (wicking).
Gaps up to 0.13 mm (0.005")
Temp. range, -54 to 149°C (-65 to 300° F)
Green Medium strength retaining compound for slip or press
fit of shafts, bearings, gears, pulleys, etc.
Gaps up to 0.13 mm (0.005")
Temp. range, -54 to 149°C (-65 to 300°F)
Brown Hydraulic sealant
Temp. range, -54 to 149°C (-65 to 300°F)
White Pipe sealant with Teflon for moderate pressures.
Temp. range, -54 to 149°C (-65 to 300°F)
Purple Form-in-place gasket for flexible joints.
Fills gaps up to 1.3 mm (0.05")
Temp. range, -54 to 149°C (-65 to 300°F)
Clear Instant adhesive for bonding rubber, metal and plas-
tics; general purpose.
For gaps up to 0.15 mm (0.006")
Read caution instructions before using.
Temp. range, -54 to 82°C (-65 to 180°F)
Threadlockers and Sealants
PART NO. -
SIZE
73287 - 10 ml
29311 - .5 ml
17380 - 50 ml
29312 - .5 ml
26685 - 10 ml
73285 - 50 ml
28824 - .5 ml
25316 - 10 ml
29314 - .5 ml
79356 - 50 ml
26695 - 6 ml
73289 - 50 ml
70735 - 50 ml
52676 - 1 oz.