Remove The Access Plugs; Remove The Access Cover; Wiring Connections Overview - Hach 5500sc Instalación

Remove the access plugs

Install cables and conduit through the electrical access ports. Refer to
sealing plugs by pushing them out from inside the enclosure to unlock the seal, and then remove
completely by pulling from the outside. Remove knockouts as necessary from the electrical access
plate with a hammer and screwdriver. To keep the enclosure rating, put a cover on all ports that are
not used.
Figure 7 Electrical access ports
1 Power in (power cord only), no ground plate. Do not
use for conduit.
2 Communication and network modules (3x)

Remove the access cover

Remove the access cover to connect to the wiring terminals. Refer to
Figure 8 Access cover removal

Wiring connections overview

Figure 9 shows all of the possible wiring connections. Make sure to use the wire gauge that is
specified for the connection (refer to
12 English
3 Communication and network modules (8x)
4 Power in or out (conduit or power cord), ground
plate, communication and network modules (8x)
Specifications on page 3).
Figure 7. Remove rubber
Figure 8.