Tabla de contenido
Publicidad
EN
E-PAK 150 DX/300 DX/500 DX
Check that all signs/markings regarding safe operation are in place and that the
personnel knows about them.
10.3
Emptying the collector bin
WARNING!
Ensure that there is no vacuum in the dust separator before removing the
collector bin.
WARNING!
Crush hazard. Pay attention when lowering and refitting the collector bin. Use
proper protective equipment.
WARNING!
Wear a protective mask.
The antistatic plastic bag is to be replaced when filled up to 2/3, see Figure 14.
NOTE!
NOTE!
the collector bin, see Figure 26.
To replace the antistatic plastic bag:
1.
Check that the risk area is clear.
2.
Ensure that there is no vacuum in the dust separator.
3.
Remove the collector bin.
4.
Seal and remove the antistatic plastic bag. Use a cable tie or equivalent,
see Figure 12.
5.
Fit a new antistatic plastic bag in the collector bin.
6.
Refit the collector bin onto the dust separator.
7.
Check that the pressure equalizer hose is attached to the collector bin, see
Figure 13.
8.
Check that the collector bin seals properly once vacuum is re-applied to
the dust separator.
CAUTION!
Never operate the unit without a Nederman antistatic plastic bag.
10.4
Replacing the main filter, control filter and filter bags
WARNING!
Always disconnect the supply voltage with the maintenance switch before any
service, whether mechanical or electrical. Always lock the maintenance switch
in the off position.
WARNING!
Ensure that there is no vacuum present in the system during service.
WARNING!
Always disconnect the compressed air supply before any service.
WARNING!
Use proper lifting and protective equipment.
42
Risk of personal injuries.
Risk of personal injuries.
Risk of personal injuries.
Use Nederman antistatic plastic bags only.
Connect the grounding clamp to the receiving vessel when emptying
Risk of equipment damage
Risk of electric shock.
Risk of personal injuries.
Risk of personal injuries.
Risk of personal injuries.
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
