Skylark 1983-1985 - Dynex DX-G1113 Guia Del Usuario

Installing your car stereo
Buick

Skylark 1983-1985

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four screws from the top edge of the instrument panel.
3 Remove the one screw from the bottom-left corner of the panel.
4 Remove two screws from the steering column trim, then remove the trim.
5 Pull up and out on the dash trim bezel, then remove it.
6 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
7 Go to "Completing the installation" on page 76.
2
S10 shown
as example
17