Cutlass Ciera 1982-1996 - Dynex DX-G1113 Guia Del Usuario

Installing your car stereo
Oldsmobile

Cutlass Ciera 1982-1996

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the ashtray, then remove the two screws from the ashtray location.
3 Remove the one screw below and the two screws above the steering column.
4 Pry the A/C vents, then remove the exposed screws in the vent compartments.
Remove the six screws from the edge of the dash trim bezel, then remove the bezel.
5 Remove the hardware that secures the factory mounting brackets to the factory head
unit. Remove and retain the brackets.
6 Go to "Completing the installation" on page 76.
2
S10 shown
as example
57