Blazer 1998-2001; S10 Pickup 1998-2001; Jimmy1998-2001; Sonoma 1998-2001 - Dynex DX-G1113 Guia Del Usuario

Juego de instalacion de equipos estereofonicos para vehiculos gm
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

28
Chevrolet

Blazer 1998-2001

S10 Pickup 1998-2001

GMC

Jimmy1998-2001

Sonoma 1998-2001

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the two 9/32-inch hex-head screws from the knee bolster.
3 Pull down on the bolster, then remove the exposed hex-head screws on the base of the
dash trim bezel.
4 Remove one Phillips screw above the instrument cluster.
5 Unclip the dash trim bezel, then remove it.
6 Remove the two 9/32-inch screws that secure the factory head unit, then disconnect
the wiring.
7 Locate bracket set 10.
8 Go to "Completing the installation" on page 76.
Installing your car stereo

Publicidad

Tabla de contenido
loading

Tabla de contenido