Corvette 1997-2004 - Dynex DX-G1113 Guia Del Usuario

40
Chevrolet

Corvette 1997-2004

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Pry out the ride control switch, then disconnect the wiring.
3 Unsnap the switch trim, then remove the two exposed 10 mm hex-head screws.
4 Open the center console door, remove 4 screws from the center hinge, then remove the
door.
5 Open the ashtray, then remove the one exposed screw.
6 Remove the ashtray, then remove the one exposed screw.
7 Unclip the small grill to the left of the ignition switch, then remove the one exposed
screw.
8 Unclip the edge of the radio trim bezel, then remove it.
9 Locate bracket set 10.
10 Go to "Completing the installation" on page 76.
Installing your car stereo