Sime ECOMAXI 160ErP Manual De Instrucciones página 60

Installation, use and maintenance manual
 Press and release
compressor LED
 Press and release the
button within 15 seconds. Please also see
parameters r3, r4 and r5;
 Press and release the
operate the appliance for 15 seconds: the
compressor LED switches off;
 Press and release the
To exit the procedure before completion:
Do not touch the display for 15 seconds (any

changes are saved).
7.1.3.5 Setting the temperature in Automatic
mode (SP2)
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and release the
on the display;
 Press and release the
button until you see "SP2";
 Press and release
compressor LED flashes;
 Press and release the
button within 15 seconds. Please also see
parameters r1, r2 and r5;
Press and release the

operate the appliance for 15 seconds: the
compressor LED (
 Press and release the
To exit the procedure before completion:
 Do not touch the display for 15 seconds (any
changes are saved).
7.1.3.6 Setting the time brackets for switching
the appliance on and off
NOTE: before
operation at pre-set times, set the
current day and time by following the
procedure in section 7.1.3.14.
To access the procedure:
 Make sure that the keypad is not locked and
that there are no other advanced procedures
running;
 Press and release the
on the display.
the button:
flashes;
button or the
button or do not
button.
button: "SP1" shows
button or the
the button:
button or the
button or do not
) switches off;
button.
activating automatic
button: "SP1" shows
the To set the first time bracket:
 Press and release the
button within 15 seconds to select "HOn1" (first
ON time) and/or "HOf1" (first OFF time);
select"HOn2" and "HOF2" for the second
ON/OFF;
 Press and release the
 Press and release the
button within 15 seconds;
 Press and release the
touch the display for 15 seconds.
To associate a time bracket with a day of the
week:
 Following on from the previous point, press and
release the
within 15 seconds to select "Hd1" (ON time for
day 1/Monday) and/or "Hd2...7" (ON time for
days 2-7/Tuesday-Sunday);
 Press and release the
 Press and release the
button within 15 seconds to select "1" (first
ON/OFF time) or "2" (second ON/OFF time);
 Press and release the
touch the display for 15 seconds;
the
To exit the procedure before completion:
 Do not touch the display for 15 seconds (any
changes are saved) or press and release the
button.
Carefully consider any activation of the
automatic ON/OFF time settings so as to
avoid causing a disservice to the users.
7.1.3.7 Displaying the operating status
 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and release the
corresponding to the current active operating
mode
(Auto/ECO/Obst/Anti).
7.1.3.8 Silencing the alarm
To silence the alarm, do as follows:
 Ensure that there is no other advanced
procedure running;
 Press any button once.
MANUAL CODE: 6328407
button or the
button;
button or the
button or do not
button or the
button;
button or the
button or do not
button: the code
is displayed for
button
3 seconds
Page 60 / 148