Setting The Day And Time - Sime ECOMAXI 160ErP Manual De Instrucciones

Installation, use and maintenance manual
7.1.3.12 Errors
Pr1 Upper boiler probe error
Solutions:
- Check that the type of probe corresponds to
the setting under parameter P0;
- Check that the probe is integral;
- Check the connection between the appliance
and the probe;
- Check the temperature of the upper part of
the boiler.
Main consequences:
- The appliance stops working.
Pr2 Lower boiler probe error
Solutions:
- As above only in relation to the probe for the
lower part of the boiler.
Main consequences:
- The appliance stops working.
Pr3 Evaporator probe error
Solutions:
- As above only in relation to the evaporator
probe.
- The appliance stops working.
When the cause of the alarm disappears, the
appliance resumes normal operation.
7.1.3.13 Defrosting
Defrosting is activated:
 Automatically, when
temperature falls below the temperature set
under parameter d17 (only if P4 is not 0);
In any case, between one defrosting cycle and
the next, the compressor must have been on for at
least d18 minutes. Otherwise, the defrosting
request is not accepted.
If P4 = 1, d2 is the evaporator temperature above
which defrosting stops. Vice versa, if P4 = 0 or P4 =
2, the parameter d2 is not considered.
If, when defrosting, the evaporator probe is above
the threshold set under parameter d2 and
parameter P4 = 1, the defrosting request is not
accepted.
the evaporator
Defrosting is made up of the following stages:
 Defrosting phase: parameter d3 determines
the maximum duration
Output statuses:
Compressor active
-
otherwise off;
Defrost relay active where d1 = 0 or d1 = 1,
-
otherwise off;
Fans on where d1 = 2, otherwise off.
-
 Dripping phase: parameter d7 determines the
duration of
Output statuses:
Compressor off;
-
Defrost relay active where d1 = 0 or d1 = 1,
-
otherwise off;
Fans off.
-
 Drying phase: parameter d16 determines the
duration of this phase. Output statuses:
Compressor according to parameter d8;
-
Defrost relay active where d1 = 0 or d1 = 1,
-
otherwise off;
Fans on.
-
If the Anti-legionella
Overboost function
defrosting is not activated.

7.1.3.14 Setting the day and time

 Make sure that the keypad is not locked
(section 7.1.3.3) and that there are no other
advanced procedures running;
 Press and release the
available code is shown on the display;
 Press and release the
button until you see "rtc";
 The day is shown in the format 1-7 (1 =
Monday, etc.).
MANUAL CODE: 6328407
of this phase.
where d1 = 1,
this phase.
function or the
is in operation,
button: the first
button or the
Page 62 / 148