Operation And Use; User Interface; Buttons And Interface - Sime ECOMAXI 160ErP Manual De Instrucciones

Installation, use and maintenance manual
7

OPERATION AND USE

The product is managed through a user interface
which allows you to:
 set the operating mode;
 change the operating parameters;
 view and manage any alarms;
 check the status of the resources.
Hereinafter, "switching on" should be
understood as the passage from stand-by
mode to ON
"switching off" should be understood as
the passage from ON mode to stand-by
mode.
Hereinafter,
procedure" should be understood as
referring to specific appliance procedures
as described in the "advanced set-up"
section.
7.1

USER INTERFACE

The user interface (Fig. 15) allows you to check and
adjust appliance operation. It is equipped with a
display and the following buttons:
 On/Stand-by button;
 SET button;
 DOWN button;
 UP button.
SET On/Stand-by
button button
Fig. 15 – User interface
7.1.1

BUTTONS AND INTERFACE

7.1.1.1 On/Stand-by button
mode, and the
the term "advanced
Display
DOWN UP
button button
Use this button to:
 turn the product on (ON status);
 put the product in stand-by mode (in this
mode,
automatically according to specific time
settings and automatically activate the anti-
legionella and defrosting functions).
When the appliance is powered up, it
keeps the same status as when the power
supply was disconnected.
7.1.1.2 [SET] button
term
Use this button to:
 confirm a selection or value set.
7.1.1.3 [UP] button
Use this button to:
 scroll up through the list of parameters;
 increase the value of a parameter.
7.1.1.4 [DOWN] button
Use this button to:
 scroll down through the list of parameters;
 decrease the value of a parameter.
7.1.1.5 Interface display
The interface display (Fig. 16) shows the:
 control temperature;
 alarm/error codes;
 status notifications;
 operating parameters.
Compressor
LED
Defrosting LED
MF LED
Fan LED
MANUAL CODE: 6328407
the appliance
Fig. 16 – User interface display
If it is on: the compressor is
active.
If it is flashing:
The compressor is in

the
switching on.
 The operating setpoint is
being modified;
If it is on: defrosting is in
progress
If it is on: the electrical resistor
on the boiler is active
If it is on: the fan is active
can operate
process of
Page 57 / 148