Changing The Driving Rollers En - Abicor Binzel ABIDRIVE CW Instructivo De Servicio

TIG cold wire feeder
5.8 Changing the driving rollers
1
2
3
Fig. 7
NOTICE
• The driving rollers should be changed whenever the wire type or the wire diameter are changed or
• Change or reverse the driving rollers always in pairs
• Observe the groove geometry and the wire diameter.
If required, the wire must be cut through and then fed in again.
 5.7 Feeding in the wire on page EN-12
1 Open cover at the ABIDRIVE CW .
2 Fold pressure lever (1) forward.
3 Swing the the pressure rocker (6) open using the pressure rolls (2).
4 Unscrew locking screws (5) from driving rollers (4).
5 Replacing the driving rollers (3) .
6 Screw in locking screws (5) and close pressure rocker (6).
7 Fold pressure lever (1) upward.
Re-adjust the required contact pressure via the pressure lever (1).
8 Close the cover.
This completes changing the driving rollers (3).
1
6
5
Pressure lever
2 pressure rolls
2 driving rollers
Changing the driving rollers
the driving rollers are worn out.
5 Putting into operation
2
3
4
4 2 full-floating axles
5 2 locking screws
6 Pressure rocker
EN - 13