HP Officejet 9100 Guía De Instalación Inicial página 5

Step 1: Back up your all-in-one settings
Before setting up the digital send authentication solution, use the EWS to back up the all-in-one
settings. After you install the digital send authentication solution, use the EWS and restore
these settings.
1. Open the EWS.
In a supported Web browser, type the IP address that has been assigned to the all-in-one.
For example, if the IP address for the all-in-one is 123.123.123.123, you would type the
following address into your Web browser: http://123.123.123.123.
2. Click the Settings tab, and then click Backup in the left pane.
3. Configure the settings for the backup, and then click Apply.
Step 2: Upgrade the firmware
Check the version of the firmware installed in the all-in-one. If necessary, use the CD included
with the digital send authentication solution to upgrade the firmware.
NOTE: Only upgrade the firmware if the version number is lower than SMR3xxxx. If the
firmware version is higher than SMR3xxxx, go to "Install the digital send authentication DIMM"
on page 6.
To check the firmware version
NOTE: You can also check the firmware version using the EWS. Click the Information tab,
and then click Device in the left pane.
1. At the control panel, press the M
2. Press
3. Press
The all-in-one prints the configuration page. The firmware version is listed in the
Device Information section of the page.
To upgrade the firmware using the CD
Select one of the following methods to upgrade the firmware.
NOTE: Before starting to upgrade the firmware, make sure the all-in-one is in the Ready state.
In addition to the methods listed below, you can use other methods to upgrade the all-in-one
firmware. For more information, visit http://www.hp.com/support/officejet9100.
1. Insert the CD into the CD-ROM drive.
2. Upgrade the firmware using one of the following options.
CAUTION: Do not attempt to print or turn off the printer until the process is completed.
ENU
(down) to move to Print report, and then press
(down) to move to Device config., and then press
Setting up the digital send authentication solution
button.
(select).
(select).
5