Setting And Storing Personal Data - Omron BF206-BT Manual Del Usuario

HBF-206IT-E_A_M.book Page 7 Wednesday, March 10, 2010 12:04 PM

4. Setting and Storing Personal Data

For the correct measurement of body composition, it is necessary to set your personal data (birth date, gender,
height). The monitor saves up to four personal profiles.
1.
Press the Personal Profile Number
button to select your personal profile
number.
The current date appears on the display, then
the display changes to the birth date (1940).
Note: When the date of birth, rather than
current date, is displayed, the settings
for that personal profile number are
finished. Please use a different
number or delete your personal profile
information. Refer to Section 4,
Deleting the Personal Data to delete
the personal data.
2.
[TO SET THE BIRTH DATE]
Setting range: 1900 to 2030
Press continuously to rapidly advance in
increments of 10.
1)
Press the GUEST/
adjust the birth year and press the SET/
MODE button to confirm.
Selecting Measurement Unit
You can change the measurement units used for the height and weight settings.
1.
Press the WEIGHT/OFF button to
turn on the power.
The current date appears on the display, then
the display changes to "0.0 kg".
2.
GUEST/ MEMO
Keep the
pressed for 2 seconds until "lb" and
"kg" blink on the display.
3.
MEMO button to
3.
4.
button
All height and weight measurements are displayed
using the new measurement units. The change
remains in effect until you change it again.
2)
Press the GUEST/ MEMO button to
adjust the birth month and press the SET/
MODE button to confirm.
3)
Press the GUEST/ MEMO button to
adjust the birth day and press the SET/
MODE button to confirm.
[TO SET THE GENDER AND
HEIGHT]
Set the gender (MALE) or (FEMALE) and
height in the same way.
After all the settings are displayed for your
confirmation, "0.0 kg" appears on the display.
This completes the setting.
You can now take measurements of your body
composition.
Press the GUEST/ MEMO button
to select "kg" or "lb".
This will also automatically change "cm" and
"inch".
Press the SET/MODE button to
confirm.
EN
7