INSTALLATION BLADE GUARD
ONLY FOR NON-DUCTED HOODS
WITHOUT FLUE
Note: Purchase Model ANKWC33
Non-ducted Recirculation Kit.
1. Do not install damper, flue mounting
brackets or flues supplied with the
range hood. Discard them.
2. Do not install 5" to 6" adapter, flex duct
or plenum supplied with the Non-duct
Recirculation Kit. Discard them.
3. Bend three blade guard tabs 90°
outward as shown. Insert front tab into
slot on top of the range hood and pivot
guard down. Fig.20.
4. Align two holes in blade guard with
holes in the range hood. Fasten the
guard to the hood with (2) 3,9 x 6mm
screws. Fig.20.
5. Plug power cord into a 120 Volt power
receptacle. Fig.21.
6. Coil excess lenght of power cord.
Tape it to the top of the range hood.
Fig.21.
SKIP TO "INSTALL FILTERS" SECTION
ON PAGE 16
- 14 -
3,9 x 6 mm.
SCREWS
FIG. 20
FIG. 21