Install The Hood - Best WC33I Manual De Instrucciones

INSTALL THE HOOD

Note: Remove the plastic protective
film from all exterior surfaces, deco-
rative flues and filters, prior to final
installation.
DUCTED and NON-DUCTED
INSTALLATION
1. Install the hood onto the wall mounting
brackets. Fig.7.
2. Remove the grease filter. Push in
latch tab to disengage filter from the
hood. Tilt the filter downward and
remove.
3. Use adjustment screw on wall
brackets to level the hood. Fig. 8.
4. From inside the hood, locate (2) holes
for drywall anchors. Mark their
location on the wall.
5. Remove hood from the wall and drill
(2) 5/16" holes. Install drywall anchors
as shown. Fig. 9.
6. Lift hood back onto wall mounting
brackets. Secure hood to the wall with
(2) 4,8 x 38mm mounting screws.
DUCTED AND NON-DUCTED
INSTALLATIONS WITH FLUE -
CONTINUE TO "INSTALL FLUE
MOUNTING BRACKET" SECTION ON
PAGE 10
NON-DUCTED INSTALLATIONS
WITHOUT FLUE -
SKIP TO "INSTALL BLADE GUARD"
SECTION ON PAGE 14
4.8 x 38 mm
SCREWS
- 9 -
FIG. 7
FIG. 8
4.8 x 38 mm
SCREWS
DRYWALL
ANCHORS
FIG. 9