Configure The System - Input And Output Configuration - Carrier 80HMA-9002 Manual De Instalación

Installation

Configure the system - Input and output configuration

Refer to pic. 7 for the terminal block pin out.
NOTE: if the input has positive configuration, input
CLOSE is read as a request. If the input has negative
configuration, input OPEN is read as a request.
Nr.
0
1 On/Off Command
7 Safety input Zone 1
9
10 Flow switch Zone 1
NOTE: if the output has positive configuration, output is
HIGH when the corresponding device has to be activated.
If the output has negative configuration, output is LOW
when corresponding device has to be activated.
Nr.
0
1
3
4
16
17 User Mode HEAT zone 1
22
23
26
33
5
80HMA - 9002
Name
Not Used
Pressure switch
OUTPUT VALUES
Name
Not Used
Pool Water Pump
Alarm X
Alarm Y
User Mode HEAT/COOL
zone 1
Proportional Valve
Open zone 1
Proportional Valve
Close zone 1
Pool Water Valve
Shut off valve
All the descriptions are referred to positive configurations.
Example:
1 if contact is close, the system switches to on
-1 if contact is open, the system switches to on
INPUT VALUES
Description
Input not used
Input from ON/OFF contact.
(Close = ON)
Safety Input (Close = Safety Active)
Pressure Switch Input (Close = Flow)
Flow Switch Input (Close = Flow)
All the descriptions are referred to positive configurations.
Example:
1 if the water pump is requested ON, the output is high
-1 if the water pump is requested ON, the output is low
Output not configured. Output always Low Level
Water Pump
Active if an error type A or B in slave board or User Interface zone 1 is
present (see diagnostic)
Active if an error type B in slave board or User Interface zone 1 is
present (see diagnostic)
User Mode state. High lever for Heating Mode
Active if Heating Mode is working
Open Command for proportional valve
Close Command for proportional valve
Pool Water Valve
Shut Off valve
Description