Electrical Connections - Nice TT6 Instrucciones Y Advertencias Para La Instalación Y El Uso

cables and control cables against possible trac-
tion or torsion.
03. Fix the control unit housing to the wall (Fig. 2).
Caution! – The receiver must be positioned so that
the cables enter the housing exclusively from the
bottom.
1
2
2 - English
4 – ELECTRICAL CONNECTIONS
Warnings
• When connecting the aerial provided, leave the wire at the
supplied length and lay it straight so as to avoid excessive
bending.
• If the control unit is not in an optimal position and the
radio signal is weak, improve reception by replacing the
aerial supplied with an external version (model ABF or
ABFKIT). The new aerial must be positioned as high as
possible and above any metal or reinforced concrete
structures present in the area.
4.1 – Inputs (Fig. 3 and Table 1)
• L Electrical phase
• N Neutral
• TTBUS: (TTBUS, GND)
• RS232 with dedicated protocol
• 5-24 VDC trigger with programmable On and Off events
– 30+30 programmable events
– Event: address, command
• Two inputs for open-close commands for 85-265 VAC
50/60 Hz mechanical motor
– Open-STOP, Close-STOP operation
– "ON-PRESS" activation
4.2 – Outputs
• Power relay output for controlling a mechanical/electronic
motor with programmable manoeuvres (up and down), acti-
vated through two button inputs Pup () and Pdown () of
the 12 V Trigger or via Transmitter.