Nice TT6 Instrucciones Y Advertencias Para La Instalación Y El Uso página 5

– The activation timer can be adjusted to between 1 sec.
and 240 sec. through the serial port with an internal com-
mand.
– The default address of the motor connected to the control
unit is 1.
Refer to Table 2 to check the LEDs present.
3
P P
DL5 P
DL4 TRG
DL6 P
DL3 DL2 DL1
DL7 RL1
PP
DL8 RL2
16
SG SG
2 3 5
RS232
TABLE 1
Wiring diagram
1 Electrical phase
2 Neutral
3 Ground
4 Up button linked to the connectable mechanical
motor
5 Down button linked to the connectable mechanical
motor
6 Mechanical motor ground
7 Mechanical motor down phase
8 Mechanical motor common contact
9 Mechanical motor up phase
10 TX signal of the RS232 interface
11 RX signal of the RS232 interface
12 Common contact (GND) of the RS 232 serial signal
13 Signal of the motor with TTBUS (White wire)
14 Common contact of the motor with TTBUS (White/
Black wire)
15 External activation trigger signal (positive pole input)
16 External activation trigger common contact (nega-
tive pole input)
ANT Aerial input
English - 3