Dip-Switches - DITEC 99 Manual De Instalación

2.4 Trimmer
TC Automatic closure time. It adjusts the time that elapses between the ending of opening control
and the beginning of the automatic closing. Time is renewed by controls 1-3A, 1-3B, H-3A, H-3B
and 41-8.
RF Motor torque. It adjusts motor torque.
RF trimmer also adjusts thrust on obstacles.
If an obstacle is present, during opening operation it stops movement, whereas during closing ope-
ration it reverts movement. After the obstacle has been removed, the door automatically searches
for its stop and continues its stroke at learning speed.
Warning: if an opening control is given with the door locked, the following opening operation will
be disabled for 15 s.
VA Opening speed. Adjust the opening speed.
VC Closing speed. Adjust the closing speed.
Note: in WELS automations, the VC trimmer adjust the closing speed only when contact 0-1 is
connected to the BRAKE card and DIP5=ON.
Adjustments according to the operating forces. Only for WELS automations without 0-1 con-
nection to the BRAKE card and DIP5=OFF. Perform the following steps:
- Set the trimmer VC=MAX. Adjust the correct closing speed as indicated in chapter 3 and ensu-
re that the manoeuvering force and the thrust between the door and the obstacle is lower than
the values set out by regulation DIN 18650-1.
- Reduce the trimmer VC adjustment and perform the opening and closing manoeuvers. Repeat
this step until you find the VC trimmer position that causes the POWER ALARM LED to light up.
- Increase by approx. 20% the VC trimmer adjustment.

2.5 Dip-Switches

Doors with no electric lock and subject to strong winds. If the wind blows the door open,
a closing force is triggered by the motor or by the spring.
Doors with electric lock. When the door is closed a closing force is maintained by the motor
or the spring.
Push&Go doors without electric lock. Manual pushing of the door activates automatic ope-
ning. When the door is closed a closing force is maintained by the motor or the spring.
Push&Go doors with electric lock. Manual pushing of the door activates automatic opening.
When the door is closed a closing force is maintained by the motor or the spring.
Description
DIP3 Electric lock fastening.
DIP4 Electric lock type.
DIP5 Spring closing.
(Only for WELS with J2=OFF)
DIP5 Closed door maintenance force.
(Only for WELM with J2=ON)
DIP6 Low energy.
Description
Description
OFF
Disabled.
Standard.
The electric lock or electric block is
generally powered off. When powered it
allows door opening.
Spring closing.
With 0-1 not connected to BRAKE card.
Normal.
Disabled.
15
MIN.
0 s
60%
0%
20°/s
4,5 s/90°
20°/s
4,5 s/90°
DIP1
OFF
OFF
ON
ON
ON
Enabled.
At approximately 20° from the closing
stop, the door thrust/speed increases
to allow proper fastening when electric
locks or electric blocks are present.
Anti-panic.
The electric lock or electric block is
generally powered. When powered off it
allows door opening.
Motor closing.
With 0-1 connected to BRAKE card.
With power supply present the door is
closed by motor whereas with power
supply off by spring.
Increased.
In environments with notable pressure
differences.
Enabled.
See chapter 4.
GB
MAX.
30 s
100%
100%
60°/s
1,5 s/90°
60°/s
1,5 s/90°
DIP2
OFF
ON
OFF
ON
99 - IP1786